Source of Trifluoroacetate counterion

{{Infobox concept | name = Trifluoroacetate counterion | subtitle = Impurity and salt form | Abbreviation = TFA salt | Arises from = Trifluoroacetic acid modifier in [[Reverse-phase HPLC|RP-HPLC]] | Typical content = 5–25% of solid mass, sequence-dependent | Alternative = Acetate, hydrochloride, by salt exchange }} '''Trifluoroacetate''' is the counterion carried by most synthetic peptides purified by [[Reverse-phase HPLC|reverse-phase chromatography]], because trifluoroacetic acid is the standard mobile-phase modifier and the peptide is isolated from that mobile phase by [[Lyophilisation|lyophilisation]].{{r|usp1503}} The counterion pairs with basic side chains — lysine, arginine, histidine — and with the N-terminal amine, so its mass fraction depends on how many basic residues the sequence carries. For a peptide with several, trifluoroacetate can be a substantial fraction of the solid, commonly cited in the range of 5–25%.{{r|roux2008}} This matters because that mass is not peptide. A vial containing 5 mg of solid at 15% trifluoroacetate and 6% water contains under 4 mg of peptide even at high chromatographic purity — which is why [[Peptide content|peptide content]] and [[Area percent purity|purity]] are separate determinations answering separate questions.{{r|usp1503}} == Origin and removal == Trifluoroacetic acid is used as an ion-pairing modifier because it sharpens peptide peaks considerably; the resulting separation is better than with most alternatives. It is also used in the cleavage step of [[Solid-phase peptide synthesis|Fmoc synthesis]], so the peptide encounters it twice.{{r|usp1503}} Removal requires salt exchange, most often by repeated lyophilisation from dilute hydrochloric or acetic acid, or by an ion-exchange step. Exchange is not free: it costs a processing step and some yield, and the resulting acetate or hydrochloride salt has its own mass contribution. Complete removal is difficult, and residual trifluoroacetate persists at low levels even after exchange. A certificate reporting an acetate salt should therefore also report residual trifluoroacetate if the exchange is to be evidenced rather than asserted.{{r|roux2008}} == Determination == Trifluoroacetate content is determined by ion chromatography with conductivity detection, by capillary electrophoresis, or by fluorine nuclear magnetic resonance. Each gives a mass fraction of trifluoroacetate in the solid.{{r|usp1503}} It is not detected by ordinary [[Reverse-phase HPLC|reverse-phase]] purity determination — it does not absorb usefully at 214 nm and elutes near the void — so a purity figure is entirely unaffected by how much of it is present. This is the clearest single example of why purity and content are not interchangeable. Nor is it a [[Residual solvent|residual solvent]] in the analytical sense: it is present as a salt rather than as free volatile acid, and a headspace gas-chromatographic method will find little of it. A certificate that reports residual solvents but not counterion has not accounted for this mass.{{r|usp467}} == Practical consequences == For content arithmetic, trifluoroacetate joins water and residual solvent as a non-peptide fraction to be subtracted. A material at 99% chromatographic purity, 15% counterion and 6% water is roughly 78% peptide by mass, and the difference between the two figures is the difference between what a purity determination measures and what a purchaser is buying.{{r|usp1503}} The water term in that arithmetic must come from a water-specific determination rather than from a total volatiles figure.{{r|usp921}} For laboratory use, trifluoroacetate is not inert. It is reported to interfere with some cell-based assays at concentrations achievable when a peptide is dissolved directly, which is why acetate salts are sometimes specified for such work. That is a research consideration and nothing here is medical advice. For reading a certificate, the useful question is simply whether counterion content is reported at all. Where it is not, the peptide mass in the vial cannot be calculated from the document, however many other determinations it carries.{{r|roux2008}} == References == {{reflist}} <ref name="usp1503">United States Pharmacopeia, General Chapter <1503>, ''Quality Attributes of Synthetic Peptide Drug Substances''.</ref> <ref name="roux2008">Roux S, Zékri E, Rousseau B, et al. "Elimination and exchange of trifluoroacetate counter-ion from cationic peptides: a critical evaluation of different approaches." ''Journal of Peptide Science'' 14(3):354–359 (2008). PMID 17994590.</ref> <ref name="usp467">United States Pharmacopeia, General Chapter <467>, ''Residual Solvents''.</ref> <ref name="usp921">United States Pharmacopeia, General Chapter <921>, ''Water Determination''.</ref> == See also == * [[Peptide content]] * [[Area percent purity]] * [[Residual solvent]] * [[Loss on drying]] * [[Reverse-phase HPLC]] * [[Underfilling]] {{DEFAULTSORT:Trifluoroacetate counterion}} [[Category:Impurities and residues]] [[Category:Analytical science]] [[Category:Purification]]