Reconstitution calculator (revision 31)
Old revision·19:36, 30 Mar 2025·Retention_Time_Rae
| Reconstitution calculatorInteractive reference tool | |
|---|---|
A U-100 syringe scale is a volume scale: 42 units is 0.42 mL regardless of what the vial contains. | |
| Inputs | Vial mass (mg), diluent volume (mL), dose (mg or µg), syringe scale |
| Outputs | Concentration, dose volume, syringe units, doses per vial |
| Method | |
| Concentration | C = m / V |
| Dose volume | Vd = D / C |
| Syringe units | U = Vd × S, S = 100, 50 or 40 per mL |
| Assumption | Negligible volume displacement by the solid |
| Scope | |
| What it is | A unit converter |
| What it is not | A clinical decision tool |
| Runs | Entirely in the browser |
| Reference tool infobox · conventions | |
The reconstitution calculator relates the four quantities involved in dissolving a lyophilised peptide and drawing a dose from it: the mass of solid in the vial, the volume of diluent added, the intended dose, and the reading on the syringe barrel. All four are connected by one division, and almost every error reported in the literature and in community accounts is a confusion between two of them rather than a failure of the arithmetic itself.[1]
The calculation is a routine unit conversion: concentration is mass divided by volume, dose volume is dose divided by concentration, and a syringe unit is one hundredth of a millilitre on the U-100 scale. The tool below performs those operations and shows each intermediate result, because the intermediate is where a mistake becomes visible.
This page is a reference tool and not a clinical decision aid. It converts numbers a reader enters; it does not select a dose, and it has no knowledge of the vial, the label claim, or the person. See Project:Medical disclaimer.
The calculator
[edit]Enter the label mass of the vial, the volume of diluent, and the intended dose. The tool reports the resulting concentration, the volume that dose occupies, the reading on the selected syringe scale, and how many doses the vial contains.
Worked examples
[edit]The tool's defaults correspond to the first row below. Each row is a division; none of them requires a calculator, and reproducing one by hand is a useful check that the inputs were entered as intended.
| Vial | Diluent | Concentration | Dose | Dose volume | U-100 units |
|---|---|---|---|---|---|
| 5 mg | 2.0 mL | 2.5 mg/mL | 0.25 mg | 0.10 mL | 10 |
| 5 mg | 2.0 mL | 2.5 mg/mL | 0.50 mg | 0.20 mL | 20 |
| 5 mg | 1.0 mL | 5.0 mg/mL | 0.25 mg | 0.05 mL | 5 |
| 10 mg | 2.0 mL | 5.0 mg/mL | 2.5 mg | 0.50 mL | 50 |
| 10 mg | 1.0 mL | 10 mg/mL | 1.0 mg | 0.10 mL | 10 |
| 15 mg | 3.0 mL | 5.0 mg/mL | 7.5 mg | 1.50 mL | 150 |
| 2 mg | 2.0 mL | 1.0 mg/mL | 100 µg | 0.10 mL | 10 |
The last row illustrates the most common unit confusion: a dose expressed in micrograms against a concentration expressed in milligrams per millilitre. One thousand micrograms is one milligram, so 100 µg of a 1 mg/mL solution is 0.1 mL — ten units on a U-100 syringe, not one hundred.
Two rows are worth noticing for a different reason. A 150-unit dose does not fit in a 1 mL insulin syringe, and the tool warns when a computed volume exceeds a plausible barrel. A 5-unit dose sits at the very bottom of a U-100 barrel, where the graduation interval is a large fraction of the dose and precision is correspondingly poor; a lower concentration would place the same dose further up the scale.[2]
What the label mass means
[edit]The calculation above treats the vial's label mass as the mass of peptide present. That is an assumption, and on a certificate of analysis it is frequently not true. A lyophilised solid contains water (typically 3–8% by mass), a counterion (2–12%), and residual salts, all of which occupy the labelled mass unless the label claim is explicitly a net peptide figure.[3]
A vial labelled 10 mg with 5.2% water and 6.4% trifluoroacetate contains approximately
10 × (1 − 0.052 − 0.064) ≈ 8.7\,mg
See also
- Reconstitution of lyophilised peptides
- Insulin syringe unit conversion
- Bacteriostatic water
- Syringe dead space
- Peptide content
References
- ^ United States Pharmacopeia, General Chapter <797>, "Pharmaceutical Compounding — Sterile Preparations". USP–NF, current revision.
- ^ ISO 7886-1, Sterile hypodermic syringes for single use — Part 1: Syringes for manual use. International Organization for Standardization.
- ^ United States Pharmacopeia, General Chapter <1503>, "Quality Attributes of Synthetic Peptide Drug Substances" (informational). USP–NF, current revision.